Basic Interactive Microsite
Pipefitters Group 2
Created on September 24, 2024
Over 30 million people build interactive content in Genially.
Check out what others have designed:
Transcript
ECITB Level 3 Pipefitting RQF
Start
Jacob Hunter-Norman Technical Discussion
Index
Home
IPS01
IPS02
IPS03
IPS04
IPS05
IPS07
IPS08
IPS10
IPS11
IPS01
Home
L3A0103-K2 The Management of Health & Safety at Work Regulations require a risk assessment which is:
PF0207-K1 Where would you find information on which type of grease to use when assembling a valve stem? PF0237-K1 You are working on top of a boiler and need to install a valve on top of the unit, where would you find information about the safety whilst conducting this task? select two answers L30207-K17 Whilst carrying out housekeeping, how should mixed waste be handled? L30205-K4 What is a Tool Box Talk? L30247-K10 Which 2 of the following should be included in the handover information?
IPS02
Home
PF0326-K6 Which pattern development methods is shown in the picture? PF0312-K2 Where would you generally find a gaseous instrumentation connection? PF0308-K2 How is the minimum bend radius of a pipe usually approximately calculated? PF0330-K3 When preparing for marking out a stainless steel pipe template, which of the following would be the best marking medium? PF0335-K4 When measuring out pipe material for fabrication, why is an allowance included in the final length? MF0334-K5 The picture shows a pipe loop, what datum point should you use to verify the bend radius?
IPS03
Home
PF0418-K4 The machined edge of a piece of carbon steel has turned blue due to over heating, what effect does this have on the material characteristics?
IPS04
Home
PF0509-K2 Which type of operating fluid medium is used in a hydraulic bending machine? PF0530-K2 When the stresses on the outside radius overcomes the ability of the tube cross section to support it - What is this describing? PF0537-K8 A completed thick wall carbon steel hydraulically formed bend is being inspected, which area should the most attention be given? PF0507-K7 You are sizing up material for a job, what would be the approximate length needed to for a 90 degrees bend length with a centre line radius of 200mm?
IPS05
Home
Link to video
Which type of gasket is recommended for sealing between dissimilar materials?The picture shows a type of sealing joint, what is it?
IPS07
Home
PF0819-K1 Which type of gasket is recommended for sealing high pressure steam flange connections? PF0802-K2 The drop in pipe level by introducing a Rise is otherwise know as what? PF0814-K3 The image shows a damaged O seal, what is the most likely cause of the damage? PF0820-K4 Where should the final set positions of a spring loaded pipe hanger be recorded?
IPS08
Home
PF1006-K2 What is a Hold Point? PF1035-K6 The picture shows a pipe under hydrostatic testing, why is this test being conducted outside? PF1037-K7,8 What is the standard practice when a section of a pipe system is completed and inspected? PF1019-K8 You wish to carry out a pipe inspection but it has been mistakenly lagged already. Which two of the following should you do about it?
IPS10
Home
PF1127-K7 Which of the following is a form of FME?PF1130-K3 Why is it important to provide engineered supports to components during dismantling operations? PF1109-K1 What is the main concern when working on old steam pipework? PF1126-K4 Which of the following is breaking containment?
Home
IPS11