GENIAL QUIZ

Aerosol Assist

Coupon Quiz

Get a $50 coupon for your demo purchase

start

Question 1/10

Where is the saliva ejector correctly inserted?

Option C

Option B

Option A

Option D

Question 2/10

If the Aerosol Assist is too loose or falls off the HVE what is most likely the issue?

Incorrect saliva ejector used

Missing or worn out “O” ring inside HVE

Too little saliva

Too wet

Question 3/10

The Aerosol Assist starts to deform / warp / deteriorate. Which of the following is NOT a likely issue that could have caused this?

Instruments / cassettes being placed on top of the Aerosol Assist

It was wiped down with a corrosive agent (i.e Alcohol, caviwipes)

Temperature setting in autoclave at a maximum of 121.111°C (250°F)

Not being placed on top rack of autoclave

It had a case of the Mondays

Question 4/10

If the Aerosol Assist cracks / deforms within 6 months what solutions are at my disposal?

Contact Aerosol Assist team via email contact@aersolassist.com with proof of purchase for replacement.

Cry

Keep using it

Order more

Question 5/10

What is the optimal position for the patient when using the Aerosol Assist?

Standing up

Upside down

Face down

Supine position

Question 6/10

What saliva ejectors can be used?

Any disposable saliva ejectors

Only clear ones

Only blue ones

Only green ones

Question 7/10

The patient says the Aerosol Assist is uncomfortable. Which of the following is NOT a likely issue that could have caused this.

The HVE hose does not have enough slack because its tangled

The saliva ejector is not positioned properly

The patient hasn't had coffee.

The patient is not sitting in a supine position

The hose is kinking on the chair

Question 8/10

There is excessive pooling of intra-oral fluids when using the Aerosol Assist. Which of the following is not a likely issue that could have caused this.

The saliva ejector ports are obstructed with portions of the patient's anatomy (ex, tongue, cheek)

The patient is very thirsty and is holding water for a later time.

The saliva ejector ports are obstructed by debri

Malposition of the saliva ejector. It’s too high up and is not positioned low enough to reach the intra-oral fluid

HVE line is not open / powerful enough

Question 9/10

Which of these can NOT be used in conjunction with the Aerosol Assist?

Bite block

Cheek retractors (ex. Optragate)

Rubber dam

HVE isolation device (ex. Dryshield, zyris products)

High speeds

Ultrasonic scalers

Lasers

Intraoral Cameras

Intraoral scanners

Question 10/10

Which of the following is NOT a way that the Aerosol Assist helps with infection control?

Can be used for lip retraction, thus keeping one hand as clean as possible.

Reduces aerosols during procedures

Taste delicious

Easier clean up for practitioner

Reduces splatter.

Congratulations!

We are very happy that you understood the correct use of the aerosol assist, use this coupon at the time of the checkout page

Your Code Is: YV9VS7KK

This coupon is for one-time use for the demo unit, it does not apply to the kits

Start over?

Try again!

Wrong!

it seems that you did not understand the explanation please check the video again and try again