Presentation CJNT CORPORATION

COMPANY OVERVIEW

CJNT CORPORATION is a private Filipino owned Company located at PTC – SEZ, Carmona, Cavite. The company was incorporated on July 7, 2010, and started operation on November, the same year.

QUALITY POLICY

CJNT Integrated Solutions Corporation, an industry engaged in cleaning services and supply of consumable products to its clients. We shall continually improve the installed Quality Management System. We commit to provide: “Customer Satisfaction through QUALITY PRODUCTS, PROMPT DELIVERY and our dedication to achieve CORPORATE SOCIAL RESPONSIBILITY and ENVIRONMENTAL DUTIES and REGULATIONS to CONTINUALLY IMPROVE a HEALTHY ATMOSPHERE and HARMONIOUS WORKPLACE.”

Our Facilities

Tubes Re-Dipping process flow

2 . Recording of data as per actual tubes and documents Received from the Customer.

1. Pick-up Tubes from Customer site.

3. Sort tubes based on the rejection criteria.

Drip Drying Blow drying& Oven Drying

4. Washing /Cleaning and re-dipping of tubes

7. Documentation, Final Packing And labeling.

6. Visual Inspection

Cleaning station

Verify D.I water using the TDS meter (specs: 0-25ppm) start of cleaning. If the D.I water is Ok, swing the basket at least 20 seconds. Drip dry tubes normally 15-30 minutes then transfer to the next process.

Dipping station

Dip a peace of tube to the solution to obtain sample of ESD 2. Record all data of the D.I water and Anti-Static result to the monitoring form Check the ESD properties must be done prior dipping process If the solution prepared ok start dipping Set the timer for 3 minutes 3. dip dry normally 10- 15 minutes.

Drying and oven station

The oven must be free from any dust After dipping let the tubes dip dry 10-15 min. but not limited For complete drying transfer the tubes to the oven and set timer control system to 2 hours before switching on the control box of oven 5minutes heat up and 1.5 hours to 3hours curing time to meet the temperature of 35-40°C. Switch on the exhaust fan for 30 minutes prior to the next process.

Final Inspection

Rejection Criteria final Inspection Ic Tubes Cracked Scratches Warp Mixed part number Wetness Dipping stain pen marking

Packing & Deliver to Customer

Trays Re-Dipping process flow

Pick-up Trays from Customer site.

Sort trays per Part Number

Mechanical & Visual Inspection.

DRYING Dip Drying Blow Drying Oven dring

Documentation, Final Packing And labeling

Cleaning of Trays

Cleaning Process for IC Tray

D.I READING IS OK. START CLEANING. 1. Brush the tray with smooth plastic brush front and back to remove any dust 2.Align the trays on a slanting diagonal position for quick drying.

FILL THE DIPPING TANK OF D.I WATER (make sure it is free from any dust and dirt)

VERIFY THE PURITIES OF D.I WATER USING THE TDS METER SPECS: 0-300ppm

DRIP DRY THE IC TRAY normally 15-30 mins.

FINAL INSPECTION

Process Inspection per type/part number one at a time. Record all the data needed to the lot traveler. Inspect per rejection criteria: Cracked/chipped White spot/stain Deformed or warp Foreign debris Missing Ribs Wetness

Packing and Deliver to Clients

Thank you for our sponsors:

Unilever Belo Medical Group Silka Papaya Ariel Bench Siomai House Pizza Pedricos Starbucks